Multi-Tooth Cutters

With its two cutting edges, this version of our milling cutter Varius® is suitable for working on harder sorts of aluminium an softer ferrous metals.

Due to its fishtail grinding, this milling cutter can dip into hard materials quite easily. It has a cost/performance ratio which is nearly unbeatable.

Due to its especially steep spiral flute of 15° chips will be removed very quickly. This allows high rates of feed.

With its 45° spiral flute, this special milling cutter for aluminium and other non-ferrous metals creates especially smooth edges of cut.

This torus cutter with its extra short cutting edge and thin layer coating is especially suitable for stainless steel.

Due to its straightly slotted flutes, this cutter only acts low drag forces on the workpiece and thus prevents the fringing of edges.

This tool has a universal grinding for machining wax, plastics and non-ferrous metals.

This tool has a universal grinding for machining wax, plastics and non-ferrous metals.

Our Varius® milling cutter with three cutting edges is especially suitable for steel, reinforced plastics and epoxide compounds. Its endurance is excellent, too.

The cutting edge geometry of this triple tooth cutter prevents the foam edges from fringing.

For milling stainless steel with little abrasive force on the workpiece, this coated triple tooth cutter is equipped with a specially shaped and very short cutting edge.

The four-toothed Varius® is used for very hard materials, e. g. for milling tempered steel, cast and other sorts of material which are difficult to machine.

Due to its different lead angles of the flutes this ratio cutter facilitates a vibration-free running and creates smoother edges of cut.