http://www.vhf.eu/en/Tools/ToolNews
Tool News
On this page we present you the novelties concerning our tool assortment. The particular link leads you to the according site in our online shop, where all new articles are especially marked.
January 2012
New double tooth cutters:This torus cutter with its extra short cutting edge and thin layer coating is especially suitable for stainless steel.
Tool range extended: Some of the vhf tools are now also available with stop ring for using them in the machines of the Impression line for typical gold works.
September 2011
Tool range extended: Single tooth cutters with polished flute are now also available with extra short and especially stable cutting edge for thin materials.
June 2011
The new catalogue informs about the tool range of vhf on 64 pages. Nearly in every tool category cutting edge geometries have been optimized or single tools have been added. Moreover, a lot of new tool types, additional cutting edge geometries and coated tools have entered the catalogue.
All innovations listed below are included in the new catalogue.
May 2011
New double tooth cutters: Due to its straightly slotted flutes, this cutter prevents the fringing of edges.
New special tool: This thread cutting tool is especially suitable for tiny threads from M 1 on.
April 2011
Tool range extended: Triple tooth cutters for foam now also available with 12 mm shank and cutting edge diameter.
February 2011
New special tool: Router bits with three cutting edges and 60° top angle for fine lines or prominent letterings – depending on the dipping depth.
December 2010
New special tool: Due to its quadrant grinding this deburring tool enables smoothly rounded edges.
New multi-tooth cutters: The new four tooth ratio cutters with asymmetric lead angles of the flutes facilitate a vibration-free running.
November 2010
New Double Tooth Cutters: Special cutters with 15° spiral flute for high-speed cutting of plastics and non-ferrous metals.
October 2010
New Single Tooth Cutters: In addition to the double tooth cutters we now offer single tooth cutters with face radius which is suitable for roughing and softer materials.
Tool range extended: XL carbide lances with cutting lengths of 50 mm and 75 mm for oscillating tangential cutting heads available.
Tool range extended: Triple tooth cutters for stainless steel now also available with shank diameters of 1.5 mm and 2.5 mm.
September 2010
New double tooth cutters: Special cutters for aluminium and other non-ferrous metals – optionally also available with the high-performance coating AluSpeed®.
August 2010
Tool range extended: PCB profile cutters now also available with greater shank diameters.
Tool range extended: Double tooth cutters with fishtail grinding now also available with greater shank diameters.
June 2010
Tool range extended: Some spiral-toothed models are now available with diamond coating.
February 2010
New drilling tools: Universal drills with 6 mm shank, coated and uncoated, for processing various materials.
January 2010
Tool range extended: Two additional cutting edge geometries for tools with 6 mm shank diameter available.